主板不过内存（Motherboard memory only）.docVIP

主板不过内存（Motherboard memory only） The main board, however, has a special memory, so well remove the memory and wipe it back. Sometimes we dont even have to turn on the machine. stay Assuming the memory is good, we look at the motherboard from the list to the difficulty of finding the reason. First of all, visual inspection, see if there is no oxidation, loose, visual oxidation, we have to wash after scraping, take tweezers in the slot gently scraping back and forth a few times, with a brush point Special washing plate water scrubbing, no washing plate water can be replaced by anhydrous alcohol. This is the reason for poor contact, the old plate appears more problems, the new plate less. Then we have to check the memory working conditions, loaded with Cpu and memory false load, plug in the test card, boot. In memory of the main power supply and load test false memory communication The voltage is 3.3 volts, SD DDR1 DDR2, 2.5 V, 1.8 V, communication is the main power supply voltage half the memory power supply is not too low. Low Xu high standard point It may be just memory, but a little higher than a bit of memory, but not too high, too high to burn memory. And memory The power supply Botaiduo miscellaneous memory will be over, the work is not stable, BSOD, waveform oscilloscope need can measure, we dont need to test, visual filter capacitor Drum package, immediately change, and sometimes visual assessment is good, but doubt it, but also immediately change, because visual inspection is not accurate, can only replace the law. When memory power is out of order, we have to run Circuit, anti power supply source, the general P4 or the same type of board is red, 5 volts or orange, 3.3 volts pass through the tube and voltage comparator, circuit principle is easy to find, simple, high The level board requires large current, which is supplied by the PWN circuit, which is similar to the single-phase power supply of the cpu. Memory as well as load voltage, and its role is memory A