串口设置（Serial port setup）.docVIP

串口设置（Serial port setup） The general is not set, first through the device manager / port in your COM port is how much, then set the corresponding port on your GX DEVELOPER serial port can be; FX series PLC parameters for 9600,7 in general, 1 bits, parity, serial communication test to see if it is the binary value of D8120 register number VB and MITSUBISHI FX2N-48MR serial communication protocol MITSUBISHI FX series PLC programming port communication protocol for example 1, DEVICE READ (read the soft device state value) computer sends to the PLC: the beginning of the first address and check digit end command STX CMD GROUP ADDRE BYTES ETX SUM Example: read 4 bytes of data from D123 STX010F604ETX74 02h 30h 31h, 30h, 46h, 36h 30h, 34h 03h 37h, 34h Address: addre =addre *2 1000h algorithm and then converted into ASCII 31h, 30h, 46h, 36h Im not too familiar with the above algorithm (1) address: addre =addre *2+1000h algorithm and how to get the 31h, 30h, 46h, 36h, can be said that the details of it? (2) sum=30h 31... 03h=74h,... Why do you want to get the 74h into 37h, 34h. this change what ah, can you explain in detail to the ah, please know that a friend told me good? My e-mail: lw2008sd@163.com A MITSUBISHI PLC programming port communication protocol of MITSUBISHI PLC programming port communication protocol is relatively simple, only four commands, i.e.: Command code device DEVICE READ CMD 0 X, Y, M, S, T, C, D DEVICE WRITE CMD 1 X, Y, M, S, T, C, D FORCE ON CMD 7 X, Y, M, S, T, C FORCE OFF CMD 8 X, Y, M, S, T, C mark five: ENQ 05H request ACK 06H PLC the correct response NAK 15H PLC error response STX 02H the start of message ETX 03H end of message The use of accumulation mode and check, frame format is as follows: STX CMD DATA... DATA ETX... SUM (upper) SUM (lower) And check: SUM= CMD+...... +ETX. Such as SUM=73H, SUM= 73. 1, DEVICE READ (read the soft state value of equipment) The computer is sent to PLC: Was the first address and check digit end command STX CMD GROU