单片机供电规则（Singlechip power supply rule）.docVIP

单片机供电规则（Singlechip power supply rule） The C8051F microcontroller is 3.3V low power consumption, high speed MCU, and the power supply 5V we used in the past the traditional low-speed microcontroller in pin processing and PCB layout will have some differences, we summed up the experience, available to everyone, in order to avoid detours in application design. First, the power and ground 1, analog and digital power supply can be used separately, respectively, two power supply voltage source, but the difference between the two power supply voltage must meet specified in the data sheet (0.5V, less than 0.3V is ideal). The output of the practical application of analog and digital power supply can be from the same regulator, simply connected between the AV+ and the VDD filter is very effective. Here we should add a small inductor, can also use the resistance of low resistance (typically 2 ohms, resistance to parasitic inductance enough. ) this approach can not only reduce the cost but also can reduce the volume. (power on the part of the principle diagram of this can be a reference to the C8051F target board). 2, on the ground, analog and digital ground to separate wiring, then in a magnetic connection, in practical applications can also use 0 ohm resistance winding connection. The winding resistance to parasitic inductance, in addition, attention must be paid to the wire in the wiring should be thick, or the covering power line, try to coarse, and between MCU power supply and all and each peripheral integrated circuit of VDD and GND between the decoupling capacitor. 3, if the analog power supply, the devices used in analog, digital power and digital ground, all these pins are not unconnected, must be connected. Two, in the harsh environment of C8051F devices, the PCB design should pay attention to those problems? The use of C8051F devices in the harsh conditions, we offer you the following general recommendations: 1) placed 0.1 F and 1 F decoupling capacitor in each power