Techlog软件WBI培训.docx

WBI培训Module 1：Data LoadingImportF4ParametersScript to be lauched=Techlog\WbiImportIMAGE-WELL2_RAW.dlisImport dataset=FMI_16_1271-1501mModule 2：Data ProcessingImage processing wizardInput data: Top=1721.4m, Bottom=1500.4m产生FMI Processing workflowInclinometry QCInclinometry QCInclinometry method parameters:Geomagnetic Components tab: 即处理向导中输入的参数Processing tab： 4种处理方法。根据Geomagnetic Components tab参数对测井得到的magnetometer 磁场和 accelerometer 加速度曲线进行刻度，算出其偏移和增益，并显示在其左边的Offsets and Gains tab中。然后利用这些偏移和增益对测量的magnetometer磁场和 accelerometer 加速度曲线进行校正，继而重新计算新井斜数据。Offsets and Gains tab：（manual法时为人工输入）Offsets tab：Measure Point Offset，Angular Offset：（人工输入）结果：校正前后数据对比，绿色表示合格，红色表示误差超限。右边交会图：黑点为校正前点子，绿点为校正后点子。中间红点为Ax, Ay, Fx, Fy偏移校正量。Continue without savingSpeed correctionCable confidence factor: 允许0-10，隐含3，越高加速度变化对测井深度的影响越小。Sticking detection threshold:遇卡加速度门槛值，小于它，表示仪器遇卡。Recovery speed:仪器解卡后速度恢复的快慢程度，越高，越快。NextArray ProcessingPad image creationImage-based speed correction (相邻电极/极板图像深度微调)Buttonharmonization：Window size for harmonization最大地层角度对应正弦线高度的三倍，且=15ft 或=5mNextNextCreate static imageDeviation 0-30 degrees: Wireline images usually oriented to North 30-45 degrees: North or top of hole according to preference 45-60 degrees: Should be oriented to Top of hole, but orientation to North can be ok 60 degrees: Must be oriented to Top of hole NextNextCreate dynamic imageDeviation 0-30 degrees: Wireline images usually oriented to North 30-45 degrees: North or top of hole according to preference 45-60 degrees: Should be oriented to Top of hole, but orientation to North can be ok 60 degrees: Must be oriented to Top of hole NextNextFinishSave the workflowModule 3：Image Display in LogViewDisplay FMI_STAT, FMI_DYNA in Logview by dragdropF4LimitsOrientationDefault value=90ProcessingGaussian smooth or Average smoothModule 4：LWD Image HandlingImportIMAGE-WELL5-LWDIMG.dlisWBIProcessingLWD Image PreparationService Company=SLBOKOKOkOkModule 5：Dip Picking打开保存的IMAGE-WELL2图选择两个image，点击右键Create a dip var