车床考试（Lathe test）.docVIP

车床考试（Lathe test） Turner exam First, individual choice questions 1 when the plane figure or line is parallel to the projection surface, the positive projection on the projection surface has (A) A, authenticity, B, accumulation, C, contraction, D, similarity When the 2 or 2 planes or lines are perpendicular to the projection plane, the positive projection on the projection surface has (B) A, authenticity, B, accumulation, C, contraction, D, similarity 3. One projection is a straight line, the other two projections are similar shapes, and the space plane is (D) A, general position surface B, horizontal plane C, parallel plane D of projection surface, vertical plane of projection surface The projection feature of the vertical projection of the 4 and 4 projection planes is that a projection accumulates into a straight line, and the other two projections are (B) A, solid B, similar shape C, phase shape D and irregular The 5 and two basic geometries contact each other in planes, called D A, tangent, B, intersection, C, combination, D, phase paste When the surface of 6 or two fundamental geometries is tangent, the line of intersection (A) is tangent A, do not draw B, should draw C, must draw D, may draw not to draw 7, the imaginary cutting plane will be part of the machine (A), painted only the section of the graph, known as section diagram A, cut B, cut C, cut D, and separate 8, the outer thread of the path should be painted (D) A, B, C, thick lines dashed dotted lines, thin lines D 9, M10--6g--L in the thread tolerance zone code, only one 6G is (B) A, top diameter without tolerance requirement, B, middle diameter and top diameter tolerance zone are 6 g C, middle diameter without tolerance requirement D, tag error 10, the first step in reading the parts diagram should be (C) to understand the general situation of the parts A, view B, technical requirement C, title bar, D, size 11 、 the technical requirement of reading parts drawing is (C) A, to understand the performance o