数学与技术（Mathematics and technology）.docVIP

数学与技术（Mathematics and technology） Five, scaffolding erection process and requirements Door type steel pipe scaffold design process is put to pull rod is fixed to the base floor casters from one end up door frame and then installed cross brace (plate), with horizontal frame bracing, loaded, loaded scissors, according to the above steps to install, by hand, foot shop installed at the top of the railing to tie the safety net. The following is the construction requirements of the portal frame: 1. Foundation The foundation of this project is the concrete floor and hard soil surface. When the scaffold is erected, the foot of the upright pole is directly placed on the ground, so as to ensure the carrying capacity and meet the erection requirements of the scaffold. 2. Portal frame (1) gantry steps / span, in line with the current industry standard door type steel pipe scaffolding (JGJ 128-2000) regulations, and cross support specifications. (2) the installation of the portal frame shall extend from one end to the other, and shall be changed by layer by layer, and shall not be carried out relatively. After taking a step, the level and verticality should be checked and adjusted according to the requirements. (3) the door frame and fittings shall not be mixed and used on the same foot rack. 3, accessories (1) throwing support, cross scissors support, horizontal frame or foot board should be installed immediately following the installation of the portal frame. (2) cross supports shall be provided on all sides of the door frame and locked with the latch on the upright pole of the frame. (3) the upper and lower door frames must be assembled with connecting rods and lock arms. The diameter of the connecting bar should be less than 1 to 2mm of the vertical rod. (4) on the operation layer, the hanging button type foot board matched with the frame and the door frame is fully fastened to prevent the foot board from falling off and loosening. (5) connect the door frame and the parts of