自动挡代码说明（Automatic code description）.docVIP

自动挡代码说明（Automatic code description） Automatic code description P is equivalent to the parking brake, used when parking and start the car R is reverse gear, used when reversing N is neutral D is the forward gear, hang this gear, refueling on the line, to a certain speed automatically add files 2 is the lock 2 files, that is, you add big oil, the car will speed up the 2 gear, will not enter the file 1 is a lock, and then refueling is also a file Manual gear, MT automatic gear, AT hand in hand, AMT..VVT is variable valve timing. Play a fuel saving role! P (Park) stands for parking, parking (off engine and idle parking for extended periods)! R (reverse) stands for reverse gear, and Im sure I dont need to explain! N (neutral gear) stands for neutral, and manual file neutral means, used for short parking! D (drive) represents the forward gear. Under this gear, the gearbox will switch automatically in the 1~5 gear according to the speed and throttle condition! Seventy-two million one hundred and fifty thousand and thirty-eight 1) P (Park), parking, parking (off the engine and longer idle parking), the gear of the drive system, the car will not slip; 2) R (rear), reverse gear 3) N, neutral, and manual neutral means, for short parking 4) D (drive), the forward gear, in this gear, the gearbox will automatically switch in the 1~5 gear according to the speed and throttle situation. D is a general drive file, which basically consists of D1, D2, and D3. Representative: D1: the most high-end is equal to the manual file (usually used in climbing 1-2) D2: the most high-end is equal to the manual file (3-4 generally used in road congestion when the stop and go) D3: 5-6 files (the most commonly used gear) for the highest grade, equal to the manual The principle of automatic gear is to adjust the gear automatically according to the speed of the car, so the general D3 can cope with the vast majority of the road. But sometimes when you need to climb steep slopes or experience manual acce