路由接口dce和dte区别（Routing interface the difference between DCE and DTE）.docVIP

下载本文档

5
0
约7.74千字
约 7页
2017-09-21 发布于河南
举报
版权申诉

路由接口dce和dte区别（Routing interface the difference between DCE and DTE）.doc

1、本文档共7页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
5、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
6、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
7、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
8、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

路由接口dce和dte区别（Routing interface the difference between DCE and DTE）

路由接口dce和dte区别（Routing interface the difference between DCE and DTE） What is the DCE? DCE: data communication equipment, DTE: data terminal equipment 1) only in synchronous communication lines will sometimes clock rate synchronization, synchronous communication to both ends of the line transmits a signal frequency, namely clock synchronization in the actual project by the protocol converter, modem line control equipment to provide, but no experimental environment special line control equipment, so by serial the interface of a router to provide. The determination of one end of the DCE is determined by the line order of the router between the cable, so the back, to, and back cable all mark DCE and DTE. 2) only DCE clock is required to mark one end of the rate 3) the frequency of the synchronous clock is not directly related to the bandwidth; 64000 refers to the addition of the transmit bit bit at a 64000 bit time interval 4) can set other values, as long as both ends can reach that standard can be, there is no impact on communication The difference between DCE and DTE? The distinction between DTE and DCE is actually just for serial ports, where routers usually connect to a wide area network via serial ports. Serial port V.24 (pin 25) usually prescribed DTE by second pin as TXD (transmit data line), third RXD (root pin receiving data line), the rest is as follows: 7 (pin signal wire, 4 DTS, 5 RTS, 6 DTR, 8 DCD, and sending a clock, receive clock and so on, have a specific pin), V.35 (34 pin) is a serial communication interface standard commonly used router, but V.35 is the use of differential signal transmission, sending and receiving are borne by the 2 signals. The DCE device is usually docked with the router, so the allocation of the pins is the opposite, that is, 2 is to receive (but also known as TXD) and 3 is to send. As a result, routers are usually DTE devices, such as modem, GV converters, etc. the transmission device is usually defined as DCE. In fact, the stan