水利工程协会质量检测员继续教育 金属结构检测试卷（The quality inspector of the Hydraulic Engineering Association continued to educate the metal structure test papers）.docVIP

水利工程协会质量检测员继续教育 金属结构检测试卷（The quality inspector of the Hydraulic Engineering Association continued to educate the metal structure test papers） Total score of test paper: 100 Exam time: 100 minutes Remaining time: 99 minutes and 50 seconds Examination paper for metal structure engineering Individual choice questions (1 points per game, 40 points) (1) the requirement of metal coating thickness inspection is (). Two The minimum local thickness shall be not less than the designed thickness More than 85% of the local thickness to meet the design requirements The minimum local thickness is 85% of the design value (2) cleaning machine tooth tip is inserted into the rack gate surface should not be less than (mm). One Five Ten Fifteen Twenty (3) the coaxiality tolerance of the two hinge shafts shall be no more than () mm. One One One point five Two Two point five (4) the diagonal difference of the moving hoist shall be less than () mm. Three Three Four Five Six (5) when the steel pipe and the bifurcated pipe adopt vibratory stress relief or explosion relief treatment, the test data before and after the weld line shall be supplied and recorded in the installation and acceptance data. Three stress Yield stress Residual stress Ultimate stress (6) the deviation of track gauge of mobile hoist is () mm. One + 2 + 3 + 4 + 5 (7) the sensitivity of magnetic particle testing to surface defects is the highest, and the defects below the surface increase rapidly with the increase of depth. Two increase reduce Unchanged (8) all connections shall be checked before and after power up test, and the insulation resistance of line shall be greater than () M ohm. Two Zero point one Zero point five One One point five (9) when designing the head, the water leakage in the water gate of any length of 1 meters shall not exceed () L/S. One Zero point one Zero point two Zero point four Zero point five (10) when the headstock test is carried out, the unbalanced three-phase current of the motor shall not