砌加气砼砌块墙（Aerated concrete block wall）.docVIP

砌加气砼砌块墙（Aerated concrete block wall） Aerated concrete block wall The technical disclosure applies to general industrial and civil buildings, autoclaved aerated concrete block wall masonry works. 1. material requirements (1) autoclaved aerated concrete blocks are generally made of 600 * 200, 600 * 250 and 600 * 300 (mm) thickness modules of 25 and 60, respectively (mm) aerated concrete blocks of two carry units. Its strength: when the dry density is 500kg / m3, the grade is MU3, and when the dry density is 700kg / m3, the grade is MU5. Design regulation For other dry density and strength grades of autoclaved aerated concrete blocks, the quality shall comply with the Ministrys standards and autoclaved aerated concrete blocks (JC31582) the requirements of the indicators. (2) cement: Ordinary portland cement or slag Portland cement No. 325 or above. Sand: medium sand, containing more than 5% of the mud, over 5mm aperture screen. (3) polyvinylformal (107 glue), precast concrete block, brick, anchor plate (75 x 50 x 3mm) phi 6 Phi 10 steel, grilled Nail (phi 4 phi 6), small wedge etc.. 2. main machines and tools (1) the background measurement equipment, mixer, 5mm sieve, trolley, shovel, shovel, saws, engraving tool belt tooth edge, Cao drill, hammer line, Supporting board, small white, ash bucket, ash spreading shovel, hammer, small bucket, bucket level, mortar and vertical transportation tools etc.. 3. operating conditions (1) site storage facilities should be solid, smooth, not water, should be neatly stacked. The shipment should be handled with care and avoid damage. And try to reduce Two times out of luck. (2) according to the wall size and block specifications, the design of masonry panel layout shall be properly arranged, and the on-site cutting capacity shall be reduced as much as possible. Masonry Block thickness and structure clearance height and size of doors and windows, arrange layout of facade and section to avoid waste. (3) place the block of aerated concre