离心泵14417（Centrifugal pump 14417）.doc

离心泵14417（Centrifugal pump 14417） I have done such a paper, but for the usual pump, first extract a part for you to see. There is hope for you. 2.1 classification of pumps There are many ways to classify pumps. Can be divided by the pump shaft location, according to the number of suction points, according to the drive pump to classify the prime mover. The most common of all methods is based on the principle and structure of the pump, which can be classified as follows: 1 、 vane pump The impeller pump is driven by the impeller to rotate the liquid at high speed, and the mechanical energy can be transferred to the liquid conveyed. According to the pump impeller and runner structure characteristics can be divided into different: 1) centrifugal pump 2) axial flow pump 3) mixed flow pump 4) vortex pumps. 2, displacement pump Displacement pump is caused by the movement of the working parts, the work volume increases periodically and reduces and attracts liquid, and the pressure of the liquid can be increased directly by the extrusion of the working parts. According to the movement of moving parts, it is divided into two parts: reciprocating pump and rotor pump. Reciprocating pump which can be divided into piston pumps, piston pumps, diaphragm pumps, etc.; rotor pumps are divided into gear pumps, screw pumps, sliding vane pumps. 3, other types of pumps: jet pumps, air lift pumps, electromagnetic pumps, etc.. This paper focuses on centrifugal pumps and reciprocating pumps. Selection of 2.2 pumps Determination of type selection parameters of 2.2.1 (1) the physical and chemical properties of the transport medium The physical and chemical properties of the conveying medium directly affect the performance, the material and the structure of the pump, and are the important factors to be considered in the selection. The physical and chemical properties of the medium include: media name, dielectric properties (e.g., corrosive, abrasive, toxic, etc.), solids content, particle size, d