成品油计量（Refined oil measurement）.docVIP

成品油计量（Refined oil measurement） Review： First, the noun explanation 1, inventory measurement to determine non moving quantity, oil pot memory and measurement data with other measuring equipment as the basis in the before and after the business day or batch operation for inventory stock, measured on the oil container. 2. Volume correction factor: the ratio of the volume of petroleum to the standard temperature and the volume at nonstandard temperature. Legal unit of measurement: the legal unit of measurement is the unit of measurement stipulated by the state in the form of compulsory use or permission to use. Flash point: 3, under specified conditions, minimum temperature flash fire when the mixture and flame contact heating oil overflow of steam and air composition, with C (c), said oil evaporation tendency and safety of the project. 4. Unit of measurement: a unit of measurement is a specific quantity that is used for quantitative representation of the same quantity value. It has a name, a symbol, and a definition, and its value is 1. 5, oil: oil refined oil, petroleum products and part of the oil refining products, including fuel oil, solvent oil and grease lubricants and related products etc.. 6, quantity transportation: according to the contract, negotiation provides the carrier of the allowable transportation loss, if more than the provisions of the carrier to bear the excessive consumption of transportation, called quantity insured transportation. At present, a lot of water transportation has adopted this mode of transportation. Sinopecs gas stations have been required to adopt this mode of transportation. 7, the highest temperature point: oil under specified conditions and cooling to stop moving, with C (c) said, is the evaluation of low temperature performance of oil project. 8, value transfer: Based on the measuring instruments verification or calibration, the measuring unit of national reference value of the reproduced, transmitted to the working measuring i