思科路由-命令（CISCO routing command）.docVIP

思科路由-命令（CISCO routing command） CISCO command Access-enable allows routers to create temporary access list entries in a dynamic access list Access-group applies the access control list (ACL) to the interface Access-list defines a standard IP ACL Access-template manually replaces the temporary access list entry on the connected router Appn sends commands to the APPN subsystem Atmsig executes the ATM signaling command B manual boot operating system Bandwidth sets the bandwidth of the interface Banner MOTD specifies date information slogans Bfe sets the emergency event manual model Boot system specifies the system image to load when the router starts Calendar sets the hardware calendar Cd change path The Cdp enable allows the interface to run the CDP protocol Clear reset function Clear counters clears the interface counter Clear interface restarts the piece logic on the interface Clockrate sets the clock rate of the serial hardware connection, such as the rate at which the network interface module and the interface processor can accept Cmt opens / closes the FDDI connection management function Config-register modify configuration register settings Configure allows you to enter the existing configuration pattern and maintain and save configuration information on the central site Configure memory loads configuration information from NVRAM The Configure terminal is manually configured from the terminal Connect opens a terminal connection Copy copy configuration or image data Copy flash TFTP backup system image file to TFTP server The Copy running-config startup-config stores the current configuration in RAM to NVRAM The Copy running-config TFTP stores the current configuration in the RAM to the network TFTP server Copy TFTP flash downloads new images from the TFTP server to Flash Copy TFTP running-config downloads configuration files from the TFTP server Debug uses debugging functions Debug dialer displays what number the interface is dialing and the like The Debug IP rip