tdr3000升级命令（Tdr3000 upgrade command）.docVIP

tdr3000升级命令（Tdr3000 upgrade command） Refer to the TDR3000 upgrade manual IU VCI 32255 VPI 031 IUB VPI 031 VCI 32127 A NASA/CASA port: vpi=0, 32=VCI=127 PVC for the time slot and equivalent to less than 32. 1bps to 4.6Mbps occupies 1 time slots; 4.6Mbps to 9.3Mbps occupies 2 time slots; 9.3Mbps to 18.7Mbps occupies 4 time slots; 18.7Mbps to 37.5Mbps occupies 8 time slots; 37.5Mbps to 75Mbps occupies 16 time slots; 75Mbps to 150Mbps occupies 32 time slots; The E.164 format is converted to NSAP 45000+E.164 (12 bits) +F+22 0 Description: landing card IP address calculation method: 11. frame number *32+, frame number *1., slot number *8+1.1, such as 2-2-4 interface board, IP address is Note: esc+k returns the previous command IP address configuration OMC RNC PC the address to configure 00 8 (must match) 00 Route to global board GCPA Route, add, 3, mask, 55, 5, -p Route, add, 4, mask, 55, 5, -p When upgrading, you need to make sure that the modified MDF file and the version of the RNC board are manually downloaded to the GCPA board via the FTP server, so first of all, you must ensure that The connection between the FTP server and the GCPA single board is normal, and the GCPA single board and the FTP server are connected via the TCSA single board (Note: the selected TCSA board must Except for the main frame (1 frames, 1 frames), other boxes of TCSA single board. Connect the FTP server to the FE3 and FE4 ports of the back card of the TCSA single board You must ensure that the TCSA single board can communicate normally with the main frame TCSA, such as that all operations are correct, and at this point the FTP server can access the physical IP address of the PING through the GCPA board. 1. Download and backup data tables Copy H:/rdbs/work/sDevVerLib.mdf, host:d:/rdbs/sDevVerLib.mdf Copy H:/rdbs/work/sDevSwPkgFiles.mdf, host:d:/rdbs/sDevSwPkgFiles.mdf Its best to back up all the data tables, add the suffix to the LDT propertys target suffix, and then start the -omc by do