爱立信GSM参数的说明 (部分).doc

8(163) 90/1553-HSC 103 12 Uen Rev B 2001-02-01 Cell data BSPWRB Type: Numeral. Range: 0 to 63. Unit: dBm. Default: – Command: RLCPC. RADIO NETWORK PARAMETERS CELL DESIGN DATA FOR ERICSSON’S GSM SYSTEM 90/1553-HSC 103 12 Uen Rev B 2001-02-01 9(163) Comments: Base Station output power in dBm for the BCCH RF channel number. The BTS can transmit with different power levels on the frequency that carries the BCCH and on the frequencies that do not carry it. The power is specified at the Power Amplifier (PA) output, i.e. immediately after the transmitter unit and before the combiner. For RBS 200 the following is valid: GSM 900: 31 to 47 dBm, odd values only GSM 1800: 33 to 45 dBm, odd values only For RBS 2000 macro the following is valid: GSM 900 (TRU: KRC 131 47/01): 35 to 43 dBm, odd values only. GSM 900 (TRU: KRC 131 47/03): 35 to 47 dBm and 49, odd values only. 49 is used to activate the feature SW Power Boost. TX diversity is used and each TX supporting the mater-slave configuration is configured 47 dBm. An BTS with filter combiner does not support SW Power Boost. GSM 1800: 33 to 45 dBm and 47, odd values only. 47 is used to activate the feature SW Power Boost. TX diversity is used and each TX supporting the mater-slave configuration is configured 45 dBm. An BTS with filter combiner does not support SW Power Boost. GSM 1900: 33 to 45 dBm and 47, odd values only. 47 is used to activate the feature SW Power Boost. TX diversity is used and each TX supporting the mater-slave configuration is configured 45 dBm. An BTS with filter combiner does not support SW Power Boost. Note: If one or more GSM TRU type KRC 131 47/01 is used within one site the maximum output power for that site shall be limited to 43 dBm. To ensure that, the parameter MPWR (see page 139) shall be set to 43 dBm for all TXs on that site. RADIO NETWORK PARAMETERS CELL DESIGN DATA FOR ERICSSON’S GSM SYSTEM 10(163) 90/1553-HSC 103 12 Uen Rev B 2001-02-01 For RBS 2301 and 2302 (micro) the following is valid: