.ProCAST2005操作手册翻译.pdfVIP

下面是ProCAST2005软件自带操作手册的部分翻译内容，从75页开始，本人E文水平极为有限，翻译内容必 有诸多错漏之处，希望各位不要见笑。 THERMAL Thermal model The Thermal module allows to perform a heat flow calculation, by solving the Fourier heat conduction equation, including the latent heat release during solidification. The typical results which can be obtained are the following : • Temperature distribution • Fraction of solid evolution • Heat flux and thermal gradients • Solidification time • Hot spots • Porosity prediction 热分析 热分析模块 热分析模块执行热流计算，通过傅立叶热传导方程，包含结晶过程的潜热计算。通过分析可以获得如下结 果： 温度分布 结晶过程的凝固状态 热流量和热梯度 凝固时间 热节 缩松（孔）预测 Flow chart This section describes the set-up of a thermal case. It is also the opportunity to introduce the general work flow of the pre-processor, as well as some aspects which may be used by different modules (e.g. symmetry). 第 1 页 共 17 页 流程图 这张图表描述了热分析案例的设置过程。这也是在pre-processor 过程通用的设置，在其他模块也同样适用。 （例如对称性设置） Geometry assignments Once the geometry is loaded, the following operations can be performed on the geometry : Symmetries can be defined at this stage (see the Thermal/Radiation section for more details). The definition of the Virtual mold is also done at this level. (see the Virtual Mold section for more details). 几何体分配 当一个几何体打开，下列菜单命令允许被执行 对称性截面可以在此设置。（查看“热辐射”一节以得到详细内容）虚拟模具也在这里设置（查看“虚 拟模具”一节以得到详细内容） In the Check Geom menu, the following features are accessible : Neg-Jac (negative Jacobian) and Neg-Area correspond to problems in the mesh. These buttons allow to locate where these problems are in the mesh in order to give indication where to modify the mesh in MeshCAST. Volumes gives access to the volume of each material domain, whereas Min-Max indicates the dimensions of the model. 在“检察几何体”菜单，有如下项目： 负雅可比单元和负雅可比区域指出了网格的错误。这两个命令指出网格的问题在哪里，以便通过 MeshCAST 进行修复。 通过体积命令可以查看指出不同区域的体积大小 Min-Max 可以查看模型各方向的尺寸。 Materials assignment Once the model is loaded (see the G