LF 单联堆冷工艺生产 X70 管线钢研究.pdfVIP

LF 单联堆冷工艺生产X70 管线钢研究 ·23 · LF 单联堆冷工艺生产X70 管线钢研究 初仁生 刘金刚 李战军 （首钢技术研究院，北京 100043 ） 摘 要 本文炼钢工艺采用单联工艺的方法生产较薄规格的X70 管线钢（厚度不大于16.1mm），即转炉→LF 精炼 →Ca 处理→连铸→堆冷，在保证产品质量的情况下取消RH 精炼工艺，降低了成本，增加了生产效率。利用扫描 电镜（SEM+EDS）等对某厂LF 单联堆冷工艺生产的较薄规格的中厚板X70 管线钢进行全面分析。从钢中气体含 量控制和钢中非金属夹杂物控制两个角度分析发现，厚度不大于16.1mm 的X70 管线钢可以用LF 单联工艺进行冶 炼。研究表明采用LF 单联堆冷工艺冶炼的X70 管线钢成分满足要求，在堆冷条件下，钢中气体成分H 含量和N 含量满足要求，非金属夹杂物各类评级均在1.5 以下，钢板探伤和钢坯内部质量满足要求。同时提出X70 管线钢非 金属夹杂物的控制策略为小尺寸、成分单一的高熔点类钙镁铝酸盐类非金属夹杂物。 关键词 非金属夹杂物，LF 单联，堆冷，控制策略 Study on the Control of Non-metallic Inclusions in Pipeline for Heavy and Medium Plate Chu Rensheng, Liu Jingang, Li Zhanjun (Shougang Research Institute of Technology, Beijing 100043, China) Abstract In the current paper, the control of gas (H and N ) and inclusions was stuied in the X70 pipeline that the 2 2 thickness is less than 16mm. The steelmaking process is Pretreatment of hot metal → LD → LF → Calcium treatment → CC → Heap cooling. The steelmaking process for no RH refining process can ensure the product quality situation, so it can reduce the cost and increase the efficiency. The size, composition and type of the non-metallic inclusions were analyzed by aspex explorer automated scanning electron microscope in X70 pipeline samples. The results show that the composition in the smelting process and the quality for the casting billet control satisfied the requirement of the steel. The control of gas content in the plate gets a high level by the technology o