二次冷却和结晶器电磁搅拌对SWRH82B碳偏析的影响Effectof.PDFVIP

二次冷却和结晶器电磁搅拌对SWRH82B 碳偏析的影响 桂仲林， 王海洋， 王向红 （中天钢铁第三炼钢厂，江苏常州21300 ） 摘 要：研究了二冷汽雾冷却和全水冷却条件下拉速、比水量和结晶器电磁搅拌对SWRH82B 碳偏析指数的影 响。结果表明：二冷汽雾冷却条件下，比水量为1.16和1.25 L/kg 时，拉速1.7 m/min 与末端电磁搅拌位置最匹配，且 随比水量由0.94 增大到1.25 L/kg ，碳偏析指数由1.17 降低到1.10，提高结晶器电磁搅拌电流由250 A 到350 A ，碳偏 析指数改善不明显；对二冷由汽雾冷却向全水冷却实施改造，得出比水量为1.6 L/kg ，拉速为1.7 m/min ，结晶器电磁 搅拌350 A/3Hz 为最佳参数，铸坯中心碳偏析平均指数达到最小值1.05 。 关键词：SWRH82B ；小方坯；全水冷却；中心碳偏析 文献标志码：A 文章编号：1005-4006 （2017 ）03-0030-04 Effect of secondary cooling and E-EMS on carbon segregation of SWRH82B billet GUI Zhong-lin ，WANG Hai-yan ，WANG Xiang-hong (Zenith Steel No.3 Steelmaking Plant，Changzhou 213000 ，Jiangsu ，China) Abstract ：Effects of continuous casting process parameters including casting speed ，second cooling water ratio and E- EMS parameters on the center segregation of SWRH82B billets under the condition of water-gas mixed and full water cooling were investigated. The results showed that in the case of cooling ration of 1.16 L/kg and 1.25 L/kg ，the casting speed 1.7 m/min was the most suitable for the F-EMS ，and the water ration increase from 0.94 L/kg to 1.25 L/kg ，the carbon segregation index decreased from 1.17 to 1.10. Increasing the electromagnetic stirring current from 250 A to 350 A ，the improvement of carbon segregation index was not obvious. By changing she secondary cooling spray nozzle from air-water mixed to water only ，it was shown that the optimal secondary cooling intensity was 1.6 L/kg ，the optimal cast- ing speed was 1.7 m/min ，E-EMS current intensity was 350A/3HZ ，then the carbon segregation reached a minimum value of 1.05. Key words ：SWRH82B ；billet ；secondary spray cooling ；central carbon segregation 高强度低松弛预应力混凝土结构用钢丝和钢 口的质量较多。小方坯强冷和结晶器电磁搅拌是 绞线SWRH82B 是高效能钢材，广泛用