DeviceNet的故障排除.docxVIP

DeviceNet的故障排除DeviceNet will not function correctly if design rules are not followed.DeviceNet的将无法正常工作，如果不遵循的设计规则。 Even a Network previously thought 即使是以前认为的网络 to be functioning correctly may begin to exhibit abnormal or anomalous operation due to incorrect system 要正确运作可能会开始表现出异常的运作不正常或因不正确的系统 design. 设计。 The following are tips to help locate and correct these abnormalities. 下面的提示，以帮助查找和纠正这些异常。 For specific DeviceNet System Installation Information. 对于特定的DeviceNet系统的安装信息。 Please refer to publication DN-6.7.2 entitled 请参见出版物的DN - 6.7.2题为 DeviceNet Planning and Installation Manual. “DeviceNet的规划和安装手册”。 Manuals can be ordered via the Automation Bookstore on the Internet at 手册可以下令在互联网上通过自动化书店“ or your local Allen-Bradley distributor or sales office. “或您当地的Allen - Bradley分销商或销售办事处。 Termination Resistors:终端电阻：A termination resistor equal to 121 Ohms 1% , 1/4W must be attached at each end of the Trunk cable. 终止121欧姆的电阻等于1％，碳膜必须附加在每个月底的干线电缆。 The The resistors must be connected across the Blue White wires of the DeviceNet cable. 电阻必须跨接电线的DeviceNet电缆的蓝与白。 Resistor connection can be verified by disconnecting DeviceNet power and measuring the resistance across 电阻连接可以验证DeviceNet电源断开，并通过测量电阻 the Can_H Can_L lines (Blue White Wire). 在Can_H＆Can_L线（蓝与白线）。 This reading should be approximately 60 Ohms. 该读数应大约60欧姆。 Important: The DeviceNet network will not operate correctly without terminating Resistors. 重要事项：在DeviceNet网络不会正确操作电阻不终止。 Termination 终止 resistors can be ordered from your local Allen-Bradley Distributor using the part number 1485A- 电阻可从网上订购当地的Allen - Bradley经销商使用 零件编号1485A -C2 .C2的 。 Page 2第2页Network Grounding:网络接地：The DeviceNet cable must by grounded at only one location. 在DeviceNet电缆必须接地的位置只有一个。 This should be done closest to the center of the 这应该是做最接近的中心 network. 网络。 connect the network Shield and Drain wire to an earth ground using #8 AWG wire up to a 连接网络屏蔽和排水管线到接地使用＃8 AWG导线多达 maximum 3m ( 10Ft ) in length.Also connect the V- conductor ( Black Wire) of the network