瘦AP网络架构.ppt

  1. 1、本文档共36页,可阅读全部内容。
  2. 2、原创力文档(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
  3. 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  4. 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
瘦AP网络架构

* * * * * * * * * * * * 连接无线控制到网络 Options - Link aggregation (LAG) or no LAG LAG supported on 440x, WiSM, Cisco 3750G integrated WLAN controller switch LAG is the only option for WiSM, Cisco 3750G integrated WLAN controller switch 440x-based controller allows 48 APs per port in the absence of LAG Use multiple “AP Manager” interfaces to support more than 48 APs on the WLC without LAG—LWAPP algorithm will load balance APs across the AP managers LAG allows use of 1 “AP Manager” interface by load-balancing traffic across an EtherChannel interface Link Aggregation—单AP Manager 接口 No EtherChannel mode negotiation (LACP, PAgP): Set “etherchannel mode on” for neighboring switchports Requires ip-src-dst load balancing for the switch Etherchannel Default on 6K Default on 3750 is scr-mac Packets are forwarded out the same port they arrived on 1 LAG group per WLC is supported In the upstream Cisco L2/L3 switch interface port-channel id switchport switchport trunk encapsulation dot1q switchport trunk native vlan native vlan id switchport trunk allowed vlan allowed vlans id switchport mode trunk no shutdown ! interface GigabitEthernet interface id switchport Channel-group id mode on no shutdown Link Aggregation: 控制器配置和交换机配置 In the WLC (WLC_CLI) config lag enable Agenda 统一无线局域网架构概述 轻量级无线接入点协议介绍 Lightweight access point protocol (LWAPP) 思科统一无线架构中的移动漫游 AP和控制器的网络连接 统一无线局域网架构中的高可用性 控制器冗余和AP负载均衡 LWAPP discovery response includes the controller’s sysName, controller type, controller AP capacity, current AP load, “Master Controller” status, AP manager IP address(es) and number of APs joined to the AP manager Recall: AP makes join decision based on this information in LWAPP discovery response: If AP has been previously configured with a primary, secondary, and/or tertiary controller, the AP will attempt to join these first (specified by controller sysName) Attempt to join a WLAN controller configured as a “Master” controller Attempt to join the WLAN controller with the greatest

文档评论(0)

pangzilva + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

1亿VIP精品文档

相关文档