SUNPOWER规格书SPEC.docxVIP

Specification,Hot Dip Galvanized SteelDocument Number: 507140 Rev AREV.EC #DESCRIPTIONDATEAUTHORAECR-001984First Release8/6/2013Chelsea Teall Gelo JuanTable of Contents1.0Scope3范围2.0Inspection33.0Non-Visual Requirements33.1Adhesion33.1.1Stout Knife Test33.1.1Bend Test (Referee Test)33.2Thickness54.0Visual Requirements64.1General Visual Requirements74.1.1ASTM A123 Excerpts74.1.2SunPower’s Interpretation of the ASTM A123 Excerpts84.1.3Mating Surfaces84.2Specific Visual Requirements94.2.1 Desired Surface Conditions104.2.2 Dross Inclusions114.2.3 Flux Deposits/Inclusions124.2.4 Excess Zinc134.2.5 Bare or Thin Spots144.2.6 Other Anomalies15Scope1.0范围This procedure describes and further defines the requirements for SunPower parts that are hot dip galvanized per ASTM A123—The Standard Specification for Zinc (Hot-Dip Galvanized) Coatings on Iron and Steel Products—or ISO 1461—Hot Dip Galvanized Coatings on Fabricated Iron and Steel Articles, Specifications and Test Methods. The galvanizer must meet the requirements given within this document. 这个程序描述和进一步定义了SUNPOWER热浸锌零件的镀锌要求 ASTMA123—铁和钢产品热浸锌涂层的标准规范。或者ISO1461—关于钢和铁装配件的热浸锌涂层的规范和测试方法。镀锌必须满足该文件资料中给出的要求。2.0 Inspection检查In accordance with Section 9.3 of ASTM A123, the material shall be inspected at the galvanizer’s plant prior to shipment. SunPower may also inspect and test the materials and accept or reject the material after shipment from the galvanizer’s plant. 与ASTMA123，9.3部分相一致，材料应该在发运到镀锌厂之前进行检查。SUNPOWER也许也监督和测试材料和接收或者材料在从镀锌厂装运发出之后。Frequency of inspection will be determined by SunPower Supplier Quality.检查的频率将由SUNPOWER供应商质量部决定。Non-Visual Requirements2.0 非可视的要求3.1Adhesion3.1附着力If a part exhibits poor adhesion, then the full replacement cost will be borne by the supplier. “Poor adhesion” includes flaking that occurs while driving piles into the ground; however, damage restricted to the top 4” of the pile during driving is not considered “poor adhesion.”如果一个件的附着力较差，然后，全部的替代成本将由供应商承担。较差的附着力包括锌层脱落发生当把桩管打入地里面；然而，桩管的损坏限制到等级4在打