WTP供水泵站.docxVIP

CNTIC BSEECJV2.Operation,MaintenanceTrouble ShootingV/P NO.PAGEPROJECT NAMEKARNAPHULI WATER SUPPLY PROJECT PHASE1(KWSP)-C1DOC.NO.CUSTOMCHITTAGONG WATER SUPPLYSEWERAGE AUTHORITY(CWASA)Rev.NO.Sub Title7.Transmission Pump MCC operations and maintenance7.Transmission Pump MCC operations and maintenanceCNTIC BSEECJV2.Operation,MaintenanceTrouble ShootingV/P NO.PAGEPROJECT NAMEKARNAPHULI WATER SUPPLY PROJECT PHASE1(KWSP)-C1DOC.NO.CUSTOMCHITTAGONG WATER SUPPLYSEWERAGE AUTHORITY(CWASA)Rev.NO.Sub Title7.Transmission Pump MCC operations and maintenance7.1 Pump starting- MV INVERTER (VFD)7.1 Pump starting-OPERATION AND MAINTAIN OF MV INVERTER (VFD)7.1.1 INSPECTION BEFORE POWER ONA, Verify the source voltage to the drive matches the drive specification. The drive’s intended input voltage is specified on the foil label located inside the control panel door. (Note: This foil label may be located in the customer connection cabinet.)B, The drive’s maximum output voltage as stated on the foil label should match the motor’s voltage rating as stated on the motor nameplate. If they do not match, contact the factory.7.1.2．Send control power of VFD. TURN THE CDS1 SWITCH ON VFD PANEL TO “ON” POSITION,SOON THE FAN BIGIN TO RUN AND HMI WORKS.A, Energize the control circuit breaker. Energize input voltage.B, Energize the medium voltage feed to the VFD. Push the Fault Reset Button on the Keypad to reset faults and alarms. Turn the mode switch from “OFF” to “LOCAL”, the Mode on the Keypad display reads KYPD.C, Push the “MANSTART” button on keypad, Spin the motor at 50% speed and observe proper rotation. Operate the drive with a Speed Demand of 60%. D, Increase the Speed Demand while monitoring the motor voltage. The motor voltage should read according to the following table for wave forms at 98.5% speed (985rpm). 7.1.3. VFD shut down： Before Push the “MANSTART” button on keypad,spin the motor low Speed Demand of 20%.then push the “MANSTOP”button,the pump and motor will stop at once.If Emergen