测频率膜厚仪程序.doc

#includereg51.h #includemath.h #define uint unsigned int #define uchar unsigned char signed long count=0; signed long houd,fq; signed long k1,k2,k3; int i=0, x=0; sbit P2_4=P2^4; sbit RS=P2^5; sbit RW=P2^6; sbit E=P2^7; //数字ASCII码放在数组中 // unsigned int shu[]={0x30,0x31,0x32,0x33,0x34,0X35,0x36,0x37,0x38,0x39}; unsigned int shu1[]={0x30,0x31,0x32,0x33,0x34,0X35,0x36,0x37,0x38,0x39}; void delay(int count) //延时 { int p; while(count--) for(p=0;p110;p++); } void write_com(unsigned int n) //写指令 { RS=0; P=n; delay(5); E=1; delay(5); E=0; } void write_data(unsigned char t) //写数据 { RS=1; P=t; delay(5); E=1; delay(5); E=0; } void time1_int(void) interrupt 3 { TH1=TL1=0; TR1=1; x++; } void time0_int(void) interrupt 1 { TH0=(65535-50000)/256; //装初值,定时50ms TL0=(65535-50000)%256; i++; if(i==20) //1s时间已到 { i=0; TR1=0; //关闭计数器1 count=(65536*x+256*TH1+TL1)*1000; x=0; if(k1==1){ fq=2.65; } else if(k2==1) { fq=2.7; } else if(k3==1) { fq=3.97; } houd=0.123*(6000000-count)/fq; TH1=TL1=0; //重新装初值 TR1=1; //重新启动计数器器 } } void show() { write_com(0x85);write_data(shu[count/100000]); delay(5); //显示十万位 write_com(0x86);write_data(shu[(count/10000)%10]); delay(5); //显示万位 write_com(0x87);write_data(shu[(count/1000)%10]); delay(5); //显示千位 write_com(0x88); write_data(shu[(count/100)%10]); delay(5); //显示百位 write_com(0x89);write_data(shu[(count/10)%10]); delay(5); //显示十位 write_com(0x8a);write_data(shu[count%10]); delay(5); //显示个位 write_com(0x83);write_data(0x66); delay(5); //显示频率表示的字符f write_com(0x84);write_data(0x3d); delay(5); //显示字符= write_com(0x8b);write_data(0x48);delay(5); //显示字母H write_com(0x8c);write_data(0x7a); delay(5); //显示字母z write_com(0xc5);write_data(shu1[houd/100000]); delay(5); //显示十万位 write_com(0xc6);writ