一步一步学 CATIA Sketch tracer.pptVIP

[Options/Shape/FreeStyle] into General tab: Tuning’s value is 0,1. Select [View/Render Style] in the top banner. Select Parallel mode Check if No attenuation mode is selected Activate the Materials display option Open the [View / Render Style] tool bar Select the Customized View Parameter icon Check the Materials option Click OK ;Design study from Sketch;Define the orientation and scale of the sketch for the elevation view Click Left view icon Drag the center of the X Y Z axis to bring it to the center of the front wheel of the car. Right-click the lower right corner of the dotted white rectangle Choose Edit Type in X = 2870 mm Click Close in the Tuner box Drag the edited point with the Zoom arrow to bring it to the center of the rear wheel of the car ;Read in the second sketch Relimit the 4views sketch Select the corner of the rectangular box Drag it to the grid as it shown. Repeat this action from this point to this one Click OK in the sketch parameter definition box. Put in place the sketch for the Top view Select the elevation sketch. Copy paste the sketch with Ctrl+C/Ctrl+V command. Double-click on the new sketch. Change the view Click the Top view icon ; Define the orientation and scale of the sketch for the Top view Drag from the center of the axis to the center of the car of the top view (plane Y=0) Drag the corner of the rectangular box. Click OK in the sketch parameter definition box ; Put in place the sketch for the other side Select the Top sketch. Copy paste the sketch with Ctrl+C/Ctrl+V command. Double-click on the new sketch. Click Flip Click OK ;Design study from Sketch;;Shape the hood central patch in a top view Using Translation in the plane (with privileged plane parallel to XY) and Linear Law, modify the rear edge of the patch to align it with the sketched edge. With the same options, modify the front edge of the patch to align it with central part of the front edge of the hood on the sketch. Modify the position of these control points.