Cisco 2811 Router 命令集(中英对照).docx

Cisco 2811 Router 命令集用户模式下：1-99 Session number to resume恢复会话数connect Open a terminal connection打开终端连接disable Turn off privileged commands关闭特权命令disconnect Disconnect an existing network connection断开现有的网络连接enable Turn on privileged commands打开特权命令exit Exit from the EXEC从执行退出logout Exit from the EXEC从执行退出ping Send echo messages发送回声信息resume Resume an active network connection恢复主动网络连接show Show running system information显示运行系统信息ssh Open a secure shell client connection打开安全壳客户端连接telnet Open a telnet connection打开telnet连接terminal Set terminal line parameters设置终点线参数traceroute Trace route to destination跟踪路由到目的地特权模式下：1-99 Session number to resume恢复会话数auto Exec level Automation执行自动化水平clear Reset functions复位功能clock Manage the system clock管理系统时钟Cisco 2811 Router 命令集特权模式下：configure Enter configuration mode输入配置模式connect Open a terminal connection打开终端连接copy Copy from one file to another从一个文件复制到另一个文件debug Debugging functions (see also undebug)调试功能（参见“undebug”）delete Delete a file删除一个文件dir List files on a filesystem文件系统中的列表文件disable Turn off privileged commands关闭特权命令disconnect Disconnect an existing network connection断开现有的网络连接enable Turn on privileged commands打开特权命令erase Erase a filesystem删除一个文件系统exit Exit from the EXEC从执行退出logout Exit from the EXEC从执行退出mkdir Create new directory创建新目录more Display the contents of a file显示文件的内容no Disable debugging informations禁用调试信息ping Send echo messages发送回声信息reload Halt and perform a cold restart停止并执行冷启动resume Resume an active network connection恢复主动网络连接rmdir Remove existing directory删除现有目录Cisco 2811 Router 命令集特权模式下：send Send a message to other tty lines将消息发送到其他tty线路setup Run the SETUP command facility运行安装命令程序show Show running system information显示运行系统信息ssh Open a secure shell client connection打开安全壳客户端连接telnet Open a telnet connection打开telnet连接terminal Set terminal line parameters设置终点线参数traceroute Trace route to destination跟踪路由到目的地undebug Disable debugging functions (see also debug)禁用调试功能（参见“调试”）vlan Configu