AIX环境下安装、卸载PowerPath.doc

AIX环境下安装PowerPath 安装软件1 将powerpath ODM上传到AIX主机下的/tmp/emc目录下，然后用uncompres命令将包文件解开；??? #uncompress /tmp/powerpath/EMC.AIX.5.3.0.1.tar.Z–xvf EMC.AIX.5.3.0.1.tar2 smitty 命令选择安装目录，安装AIX ODM??? #smitty installp3 将powerpath4.5.3 for AIX上传到AIX主机下的/tmp/emc/powerpah目录下，然后用gunzip命令将包文件解开；??? #gunzip /tmp/emc/powerpath/EMCpower.AIX.4.5.3.patch.tar.gz–xvf EMCpower.AIX.4.5.3.tar4 smitty 命令选择安装目录，安装powerpath软件??? #smitty installp5.确认powerpath是否安装成功? #lslpp -l|grep power6.注册PowerPath软件? #emcpreg –install7.#cfgmgr -v? //确保系统认到新的hdiskpower and hdisk#powermt config?? //执行powermt命令识别POWERPATH设备#powermt display dev=all //检查POWERPATH设备识别情况,policy为SymmOpt#powermt save???? //保存POWERPATH配置1 lslpp -l|grep power //检查powerpath安装的版本 2 smitty remove 3 选择要卸载的powerpath，Esc+7选择 4 回车确定卸载 5 lslpp -l|grep power //检查是否卸载成功 配制HACMP /usr/sbin/cluster/utilities/clcustomdisk -c -tdisk/pseudo/power -Ndisk/pseudo/power -gSCSI3 -hSCSI_TUR -b/usr/lpp/EMC/Symmetrix/bin/emcpowerreset -ptrue -mMKDEV odmget HACMPdisktype 1 安装PowerPath的集群AIX平台使用EMC Symmetrix磁盘注意事项 1.1 在HACMP中设置emcpowerreset以及break reserves in parallel =true 为保证HACMP能够顺利切换并且最大限度地加快切换速度, 需要在HACMP配置中遵循以下指导: For HACMP 5.1 and higher (SMIT) 1. Enter into the SMIT fastpath for HACMP smitty hacmp. 2. Select Extended Configuration. 3. Select Extended Resource Configuration. 4. Select HACMP Extended Resources Configuration. 5. Select Configure Custom Disk Methods. 6. Select Add Custom Disk Methods. 7. The following fields are available, enter as follows; For IBM Fibre Channel configurations with PowerPath 3.0.3 and higher: Disk Type (PdDvLn field from CuDv) = disk/pseudo/power Method to identify ghost disks = SCSI3 Method to determine if a reserve is held = SCSI_TUR Method to break a reserve = /usr/lpp/EMC/Symmetrix/bin/emcpowerreset Break reserves in parallel = true Method to make the disk available = MKDEV 8. Configure the same custom disk processing method on each node in the cluster and synchronize the