GCA 2006 座椅部分_(通用06年最新标准).doc

7. 缺陷的响应系统DISCREPANCY RESPONSE SYSTEM 所有的50分和10分的缺陷应该由工厂最优先消除。每个地区在工厂要按照如下流程图建立纠正消除措施的流程。 All Factor 50 and Factor 10 items are to be driven to zero with the highest priority. Each region will establish corrective action / containment requirements in line with the flow chart shown below. 7. 座椅（每个座椅每种缺陷最多记一个缺陷） Seats (one discrepancy per defect per seat maximum)  定义：一个座椅的定义是一个座椅总成（独立的座椅指驾驶椅/副驾驶椅）或者是个长椅。 Definition: A seat is defined as one bucket (independent seat intended for one driver / passenger) or one bench seat.  缺陷DEFECT 描述DESCRIPTION 分值 WEIGHT FACTOR 任何会造成安全/法规影响的情况（见安全项目部分） Any condition resulting in a safety / legal impact (See safety section) Any 50 断裂/损伤Broken / Damaged Any 10 脏（能够用蘸水的布或者干布清除） Clean Up (can be cleaned with water or dry cloth) Any 1 脏（不能够用蘸水的布或者干布清除） Clean Up (cannot be cleaned with water or dry cloth) Any 5 针脚切断，跳针脚Cuts, Open seams Any 10 发泡物质损伤 Damaged foam 10mm 1 10mm 10 操作力 Effort 和其它相同型号的车辆有差异 Deviation from vehicles of same model 10 4/6开或者5/5开后座椅靠背过大的间隙/对齐度Excessive gapping / poor alignment of rear seat back (RSB) (60/40 or 50/50) panel 10mm 5 多余的材料Excessive material 与该车上或相同车型的座椅有差异 Deviation from seats in the same vehicle or same model 1 打孔的座椅皮革/面料孔内有多余的材料 Excessive material in holes of perforated leather / materials Any 1 外露/多余的线头（进入车内或者坐在座椅上可以看到）Exposed / Hanging wiring (when viewed upon entering vehicle or sitting in any seat) Any 5 泡沫外露（进入车内或者坐在座椅上可以看到） Exposed foam (when viewed upon entering vehicle or sitting in any seat) Any 1 座椅（续上）Seats (continued) 缺陷DEFECT 描述DESCRIPTION 分值 WEIGHT FACTOR 当进入车辆或者坐在座位上看到金属结构件外露Exposed structural metal when viewed upon entering vehicle or sitting in any seat 除非是设计允许 Any except allowed by design 1 功能（包括：中央扶手，腰托，调角器，座椅位置记忆，座椅升降，座椅前后滑动，等等）Function (includes: center arm rest, lumbar adjustment, recliners, seat catch, seat raising, seat slides, etc.) 任何Any 10 座椅靠背和坐垫之间的间隙 Gapping between seat back and cushion. 10mm 1 20mm 5 塑料饰盖与座椅发泡材料之间的间隙 Gaps