ROS3.30全套多线负载平衡设置脚本.doc

ROS3.30设置脚本 如果你是菜鸟，下面的脚本也许会帮了，如果你是高高手，请你多指证，谢谢 下面是我花了一整天的时间整理出来的，第一次用ROS3.30，走了很多弯路，还好以前有点2.9的基础，结合在网上找些前辈门的脚本，终于测试一切正常，我自己在我的线路上测试通过，如果到你机器上有问题，请嘴上留情，别骂我，请仔细检查，相信你也一定能行的。如果有问题实在搞不懂，可以加我QQ307237303（请先自己多钻研一下在加我） # dec/03/2011 20:55:29 by RouterOS 3.30 # software id = K6BP-MUXD # /interface ethernet set 0 arp=enabled auto-negotiation=yes cable-settings=default comment= \ disable-running-check=yes disabled=no full-duplex=yes mac-address=\ 00:03:47:95:C8:66 mtu=1500 name=WAN3 speed=100Mbps set 1 arp=enabled auto-negotiation=yes cable-settings=default comment= \ disable-running-check=yes disabled=no full-duplex=yes mac-address=\ 00:03:47:95:C2:FC mtu=1500 name=LAN speed=100Mbps set 2 arp=enabled auto-negotiation=yes cable-settings=default comment= \ disable-running-check=yes disabled=no full-duplex=yes mac-address=\ 00:20:ED:1C:B3:90 mtu=1500 name=WAN1 speed=100Mbps set 3 arp=enabled auto-negotiation=yes cable-settings=default comment= \ disable-running-check=yes disabled=no full-duplex=yes mac-address=\ 00:20:ED:1C:B3:91 mtu=1500 name=WAN2 speed=100Mbps 以上是网卡名称设置 /ip pool add name=PPPOE-IP ranges=-00 以上是PPPOE拔号地址池 /port set 0 baud-rate=9600 data-bits=8 flow-control=hardware name=serial0 parity=\ none stop-bits=1 set 1 baud-rate=9600 data-bits=8 flow-control=hardware name=serial1 parity=\ none stop-bits=1 以上是导出后不知用处的 /ppp profile set default change-tcp-mss=yes comment= name=default only-one=default \ use-compression=default use-encryption=default use-vj-compression=default add change-tcp-mss=default comment= dns-server= local-address=\ name=PPPOE-1 only-one=yes rate-limit=\ 108k/1400k 128k/1600k 90k/1m remote-address=PPPOE-IP use-compression=\ default use-encryption=default use-vj-compression=default wins-server=\ 8 add change-tcp-mss=default comment= dns-server= local-address=\ name=LOW only-one=yes rate-limit=88k/900k 108k/1100k 90k/1m \ remote-address=PPPOE-IP use-compression=default use-encryption=de