电气检修项目(rev.5).docVIP

电气专业检查项目 Electrical Section First Inspection Item 序号 No 部件名称 Equipment No 标准项目 Items 备注 Remarked 1 汽轮发电机（水氢氢） Turbine generator 定子端部手包绝缘部位检查 Visual checking the insulation box of end of stator 定子出线、中性点包括出线套管、接线端面、互感器、箱罩等清扫、检查； Cleaning outlet and nature including bushing、termination、CT and box 滑环、刷架装置清扫 Cleaning the brush and support 发电机轴承对地绝缘测量检查 Insulation measuring and checking the bearing of generator to grounding 发电机绝缘测量 Insulation test for generator 2 柴油发电机 Diesel generator 发电机引线和出线盒清扫、检查 Cleaning and visual checking the outlet termination box 发电机出线开关柜及柜内断路器检查 Visual checking the CB at the generator outlet panel 发电机出线动力电缆检查 Visual checking the outlet power cable of generator 控制部分检查： Checking for control part 4.1.保护、控制、信号二次回路清扫检查、端子紧固 Visual checking and cleaning all the control loop and tighten the termination 4.2.交、直流回路绝缘电阻 Measuring the insulation for AC source and DC source loop 4.3.保护、控制、信号二次回路传动试验 Transmission test for the secondary loop 发电机功能试验 Function test for diesel generator (generator start and shut down test) 3 主变压器 （油浸变压器） Main transformer 1.本体绝缘油检查（微水、气体分析、耐压、介损试验分析） calibration for insulator oil (water content、gas analysis 、AC withstand, tan delta) 2.外壳及其附件清扫、渗漏检查 Visual cleaning and leakage check for the cover and accessories 3.瓦斯继电器检查 Visual Checking the gas relay 4.呼吸器检查 Visual Checking the breather 5.主变外观渗油检查 Visual check and oil leakage checking for body 6.主变外部接地检查 Checking grounding cable for main transformer 7.冷却系统控制柜（箱）电气回路、电缆检查 Checking the loop and cables in cooling system control panel 8.油流继电器及其电气回路、电缆检查 Loop and cable visual checking for oil indication 9.变压器外观清理 Cleaning for the visual main transformer 10.出线及中性点套管瓷套表面清洁，裂纹、放电痕迹检查 Cleaning the surface of bushing for outlet and natural, checking the flaw and power discharge trace 11.主变高低压侧引线接头检查 Visual Checking for the HV side and LV side termination