bladed需要控制参数.docVIP

Control system Torque-speed curve rated额定风速下扭矩-速度曲线 Optimal mode gain最优模式的增益: 0.177 Minmum generator speed最小发电机转速:1000 Optimal mode maximum speed最优模式最大电机转速:1710 Above rated: pitch regulated speed Minmum pitch angle: 0 Maximum pitch angle:90 Demanded generator torque: 5676 Demanded generator speed: 1710 Transducers Power transducer time constant: 0 Speed sensor constant: 0 Pitch control: software rate limits Minimum pitch rate: Maximum pitch rate: Pitch Actuator变桨执行器: Pitch position demand Pitch rate demand Torque control/ Pitch control——Discrete external controller Supervisory control监控: Start-up开始启动 Initial rotor speed初始叶轮转速：0 Initial pitch angle初始变桨角度：90 Initial pitch rate during start-up启动时初始变桨速率 Generator speed at which generator is put on line：1000 Final pitch angle in start-up mode：0 Normal stop Pitch rate:8 Final pitch:90 Rotor speed for cut in of shaft brake:24.16 Emergency stop Rotor overspeed trip to start pitching:29.24 Emergency pitch rate:12 Final pitch:90 Rotor overspeed trip for brake application:？？ Rotor speed for brake application for parking:1.462 Brake Properties for shaft brake: 1 Torque vs time table Parked Pitch angle when parked:90 Rotor azimuth when parked: 0 Iding Pitch angle for idling: 90 Yaw control偏航控制 Yaw dynamics偏航动态特性 None机舱角固定 Rigid yaw刚性偏航√ Yaw friction偏航摩擦力—— Flexible yaw柔性偏航 Controlled torque扭矩控制 Active yaw主动偏航 None机舱角固定为0（正北） Prescribed manoeuvre固定动作 Time to start yaw manoeuvre偏航动作起始时间—— Required yaw position change要求的偏航位置变化—— Yaw rate for yaw manoeuvres偏航动作的偏航速率——0.4°/s，最小0.15°/s External controller外部控制器 Yaw faults偏航故障 Time of yaw fault偏航故障时间——？types of yaw fault偏航故障类型 Constant flaiure rate恒定故障速率——？？/apply stop at停止位置—— Constant flaiure torque恒定故障扭矩—— Free/Constrained自由/受限 linear yaw flaiure stiffness线性偏航故障刚性—— linear yaw flaiure damping线性偏航故障阻尼—— yaw flaiure friction偏航故障摩擦力—— XXX XXX Time of yaw fault——？types of yaw fault Constant rate Constant torque Free/Constrained