斯巴鲁汽车IPMREZA WRX STI翼豹维修手册-19. Cylinder Head Assembly.pdfVIP

CYLINDER HEAD ASSEMBLY MECHANICAL 19.Cylinder Head Assembly B: INSTALLATION 1) Install the cylinder head and gaskets on cylinder A: REMOVAL block. 1) Remove the V-belt. Ref. to ME(STi)-41, RE- NOTE: MOVAL, V-belt. 2) Remove the crankshaft pulley. Ref. to ME(STi)- • Use new cylinder head gaskets. 44, REMOVAL, Crankshaft Pulley. • Be careful not to scratch the mating surface of 3) Remove the timing belt cover. Ref. to ME(STi)- cylinder head and cylinder block. 45, REMOVAL, Timing Belt Cover. 2) Tighten the cylinder head bolts. 4) Remove the timing belt assembly. Ref. to (1) Apply a coat of engine oil to the washers and ME(STi)-46, REMOVAL, Timing Belt Assembly. bolt threads. 5) Remove the camshaft sprocket. Ref. to (2) Tighten all bolts to 29 N·m (3.0 kgf-m, 22 ft- ME(STi)-54, REMOVAL, Camshaft Sprocket. lb) in alphabetical sequence. 6) Remove the intake manifold. Ref. to FU(STi)- (3) Tighten all bolts to 69 N·m (7.0 kgf-m, 51 ft- 14, REMOVAL, Intake Manifold. lb) in alphabetical sequence again. 7) Remove the bolt which installs the A/C compres- (4) Back off all bolts by 180° first; back them off sor bracket on cylinder head. by 180° again in reverse order of installation. 8) Remove the camshaft. Ref. to ME(STi)-57, RE- (5) Tighten all