AIX平台下EMC阵列安装与配置.docVIP

AIX平台下EMC阵列安装与配置 一 AIX ODM包安装 1.安装ODM注意事项 A．关于FCP \MPIO \FCP PowerMPIO 以下三个filesets不能共存，只能选其一 EMC CLARiiON FCP Support Software： IBM Fibre Channel driver support. EMC CLARiiON FCP MPIO Support Software： IBM default PCM MPIO support. EMC CLARiiON FCP PowerMPIO Support Software： PowerPath custom PCM MPIO support. Note: When installing either Symmetrix or CLARiiON FCP fileset support,only one default device type can be installed for either storage array.Coexistence support for FCP, FCP MPIO, FCP PowerMPIO for the same array type isnt supported. The installp pre-installation scripts check for this and will not allow you to perform. such actions. B．关于CLARiiON High Availability Support HACMP RAC环境中需要安装CLARiiON High Availability Support。安装该为文件集之前，需要先安装HACMP，因为EMC CLARiiON HA Concurrent Support依赖以下filesets才能安装 cluster.es.server.rte cluster.base.server.rte Release Notes for CLARiiON High Availability Support The EMC CLARiiON HA support software fileset is installed on AIX based machines using the `installp` command. This fileset provides a utility called `clarcurrent` to add and delete CLARiiON device types into the clconraid.dat configuration file. The clconraid.dat file is a member of the HACMP concurrent fileset cluster.base.server.diag or cluster.es.server.diag. C．关于emcpowerreset 安装ODM库后，就会在/usr/lpp/EMC/CLARiiON/bin/目录下生成该文件。 The utility is used for resetting a device reservation with HACMP for PowerPath 3.0.3,3.0.4, 4.X and higher. This utility is version 2. Previous version isnt supported with PowerPath version 4.X and higher. To determine the different emcpowerreset,versions run the following command. #cksum emcpowerreset Version 1 = 1108394902 7867 emcpowerreset Version 2 = 1955156125 10311 emcpowerreset In a non-cooperative node failover, the takeover node cannot always clear the SCSI device reservation held by the primary node. The problem occurs when the takeover node cannot always clear the SCSI device reservation held by the