Chapter10 Gears 机械零件设计英文PPT全套教案.pptVIP

(3) Design for surface strength the factor of overlap-ratio the reduction-ratio * * Checking and design calculation for surface strength of gears * Choice of gear width ratio should never exceed the values given in Table 10.3. In design calculations, the values generally varies within a wide range:0.1-1.2, and is specified on the basis of the following considerations. For closed-type medium-speed gears of medium power is taken in the range of 0.4-0.6. In open-type gears where the accuracy of assembly and rigidity of the bearings is not high, ≤0.3. Th