程控升压开关电源(论文).docVIP

程控升压开关电源的设计 摘 要 随着现代的科技发展，很多领域的电源系统中都用到了DC-DC电源模块。因相应技术的提高，电源系统的性能极其使用的价值都有了更高的要求。像对电源的体积、功耗、及其输出功率和成本等的要求。 本文介绍的程控升压开关电源，正是基于实现以上思想的基础上来设计的。设计的过程中，分为硬件设计和软件设计两个部分，但不论是硬件还是软件上都采用了模块化的思想，使设计的作品结构清晰切易于发现和改进它在各个方面的不足。 设计作品主要分为由MC34063芯片组成的DC/DC升压变换模块和由STC12C5410AD单片机组成的控制模块组成。另外还包括了键盘模块和LED显示模块等。DC/DC升压变换模块用来完成对直流电压的升压，而中心控制模块则用来控制对输出的电压电流数据的采集极其显示，及对直流电压升降的程控。键盘的输入是程控电压升降大小的参数，LED显示模块则用来显示整个系统输出的电压电流的大小。 设计作品具有体积小、功耗底、输出功率大及价格相对便宜等优点。它基本符合了现在很电源领域的应用。 关键词：程控，DC/DC升压变换，STC12C5410AD单片机，LED显示。 DESIGN OF BOOST PROGRAM－CONTROLLED SWITCHING POWER SUPPLY ABSTRACT With modern science and technology development, many areas of power systems are used in the DC-DC power modules. Appropriate technology for the improvement of power supply system used in the performance of most value have a higher demand. Like the power of size, power consumption, and its output power and cost requirements. This paper describes the step-up program-controlled switching power supply, is based on the realization of the above ideas on the basis of the design. In the process of design, hardware design and software design is divided into two parts, but no matter what hardware and software used on a modular thinking. Design works were mainly composed of the MC34063 chip DC / DC Boost transform STC12C5410AD SCM modules and components from the control module. It also includes a keyboard module and LED display module. DC / DC Boost module used to complete the transformation of the step-up DC voltage, The center control module is used to control the output voltage and current data collection is extremely, and the DC voltage of the program-controlled movements. Keyboard input voltage is programmed movements of the size parameters, LED display module is used to show the whole system output voltage and current size. Design work is small in size, power consumption at the end of the output power and price advantages of relatively cheap. It is now basically in line with the power of the application. KEY WORD