设计一个带控制端的逻辑运算电路,分别完成正整数的平方、立方和阶乘的运算.docVIP

练习：设计一个带控制端的逻辑运算电路，分别完成正整数的平方、立方和阶乘的运算。 //--------------myfunction---------- module myfunction(clk,n,result,reset,sl); output[6:0] result; input[2:0] n; input reset,clk; input [1:0] sl; reg[6:0] result;//define input and output always @(posedge clk) begin if(!reset) result=0; else begin case(sl) 2d0: result=square(n); 2d1: result=cubic(n); 2d2: result=factorial(n); endcase end end function[6:0] square; input [2:0] operand; begin square=operand*operand; end endfunction function[6:0] cubic; input [2:0] operand; begin cubic=operand*operand*operand; end endfunction function[6:0] factorial; input [2:0] operand; reg [2:0] index; begin factorial = 1 ; for(index = 2; index = operand; index = index + 1) factorial = index * factorial; end endfunction endmodule //--------------testmyfunc---------- `include ./myfunction.v `timescale 1ns/100ps `define clk_cycle 50 module testmyfunc; reg[2:0] n; reg reset,clk; reg[1:0] sl; wire[6:0] result; parameter times=20; initial begin n=0; reset=1; clk=0; sl=0; #100 reset=0; #100 reset=1; repeat(times) begin #50 sl={$random}%3; #50 n={$random}%6; end #1000 $stop; end always #`clk_cycle clk=~clk; myfunction myfunct(.clk(clk),.n(n),.result(result),.reset(reset),.sl(sl)); endmodule