110kV输变电工程电气主接线设计.docVIP

论文 110kV输变电工程电气主接线设计 110kV输变电工程电气主接线设计 摘 要 本次任务是设计沙渠V和V两个电压等级，主变容量、报装容量确定。V进线方式和接线距离确定，接线方式采用先架空线后电缆的方式双回供电；出线15个工业项目，设计的主要内容包括：根据可靠性和灵活性为基础综合分析各种主接线方式的优劣势、特点和适用范围，分别选择两个电压等级最合理适用的主接线方式。再根据原始资料选择经济适用的主变压器，通过对主接线的短路计算，选择其他必要的电气设备并进行校验，进行防雷、接地保护，并通过设备的选择绘制主接线图。 Design of Electrical Main Wiring for 110kV Power Transmission and Transformation Project Abstract This task is based on the task book and the basic requirements of the design of the shaqu 110kV step-down substation part 1, there are two voltage levels of 110kV and 10kV and the main variable capacity, reported capacity is determined. 110kV line way and wiring distance determined, the wiring method using the first overhead line after the cable double power supply; outlet 18 back to supply 15 industrial projects, 7 agricultural projects and 12 residential area. Weather environmental factors, annual thunderstorm days known. The main contents of the design: According to the reliability and flexibility based on a comprehensive analysis of the main wiring of the advantages and disadvantages, characteristics and scope of application, respectively, select the two voltage levels of the most reasonable application of the main wiring. And then select the economically applicable main transformer according to the original data, through the short circuit calculation of the main wiring, select the other necessary electrical equipment and check, mine, ground protection, and through the selection of equipment to draw the main wiring diagram. Key words: substation; main wiring; short circuit calculation; electrical equipment selection; lightning protection 目 录 论文总页数：39页 1 引言 1 1.1 课题背景 1 1.2 国内外研究现状 1 1.3 本课题研究的意义 1 1.4 本课题的研究方法 2 2 原始资料分析 2 3 变电站电气主接线设计 2 3.1 电气主接线设计概述 2 3.2 电气主接线的初步方案选择设计 3 3.3 电气主接线方案的比较 7 3.3.1 技术比较 7 3.3.2 经济比较 7 3.4主变压器的选择 8 3.5站用变压器的选择 8 3.6低压电容器的选择 8 4 短路电流计算 9 4.1 主要元件的电抗 9 4.1.1 线路电抗的计算 9 4.1.2 变压器 9 4.2 计算短路电流 10 4.2.1 短路点d1 10 4.2.2 短路点d2 10 5 变电站导体和电器选择设计 11 5.1 断路器的选择 13 5.1.1 10kV母联和主变侧断路器选择和