超声波LCD12864显示测距程序.doc

/******************************************************************************/ /* Name: LCD12864(St7920/St7921)+超声波测距模块+STC89C52 */ /* DYP-ME007 超声波测距模块 DEMO 程序 */ /* 晶振：11.0592M */ */ /* 接线：模块TRIG接 P1.2 ECH0 接P1.1 */ /* RS(CS) 接 P3.3; */ /* RW(SID) 接 P3.4; */ /* E(SCLK) 接 P3.5; */ /* PSB 接 GND 串行模式 */ /******************************************************************************/ #include AT89X51.H #include intrins.h //引脚定义 sbit RX = P1 ^ 1; sbit TX = P1 ^ 2; sbit CS = P3 ^ 3; //片选 高电平有效 单片LCD使用时可固定高电平 sbit SID = P3 ^ 4; //数据 sbit SCLK = P3 ^ 5; //时钟 //Function Definition　函数声明 void Delay(int num); void Init_DS18B20(void); unsigned char ReadOneChar(void); void WriteOneChar(unsigned char dat); unsigned int ReadTemperature(void); void clock_out(unsigned char dd); unsigned char clock_in(void); unsigned char read_clock(unsigned char ord); void write_clock(unsigned char ord, unsigned char dd); void Disp(void); void id_case1_key(void); void id_case2_key(void); void Set_time(unsigned char sel,bit sel_1); void Timer0_Init(void); void Init_1302(void); void Set_Bell(unsigned char sel, bit sel_1); void Bell(void); //12864 void Write_char(bit start, unsigned char ddata); void Send_byte(unsigned char bbyte); void Delaynms(unsigned int di); void Lcd_init(void); void Disp_img(unsigned char *img); void LCD_Write_string(unsigned char X,unsigned char Y,unsigned char *s); void LCD_set_xy( unsigned char x, unsigned char y ); unsigned char code num[]={ :.-}; unsigned char code waves[]={超声波测距系统}; unsigned char code znwk[] ={智能微控工作室}; unsigned char code CM[] = {M}; unsigned int time=0; long S=0; bit flag =0; unsigned char disbuff[4] ={ 0,0,0,0,}; unsigned char code log