某塔装置工程脚手架搭设施工方案(英汉互译).docVIP

目 录 Content 1 工程概况General………………………………………………………………………1 2 施工依据 References……………………………………………………………………1 3施工程序 Construction Procedures……………………………………………………1 4施工技术要求 Construction Technical Requirements……………………………………2 5脚手架计算书 Scaffolding Calculation……………………………………………………7 6 HSE措施 HSE Measures …………………………………………………………………9 工程概况 General 此方案用于--装置C4450、C3170、C3140、R4420、V2704、V3090、V3091、V3100、V3120、V3130、V3172脚手架搭设，脚手架用来进行平台爬梯安装工作。 This method statement is prepared for the scaffolding erection for the platform ladder installation of C4450、C3170、C3140、R4420、V2704、V3090、V3091、V3100、V3120、V3130、V3172 in. 编制依据 References: 《扣件式钢管脚手架搭设要求与设计计算》JGJ 130-2001 Erection Requirements and Design Calculation for the Steel Tubular Scaffold with Fastener JGJ 130-2001 《石油化工企业施工安全技术规程》SH3505-1999 Safety Technical Regulations for Petrochemical Construction SH3505-1999 施工程序 Construction Procedures 施工技术要求 Construction Technical Requirements 地面处理 Ground Preparation 架设前放置立杆底座板，立杆插放在底座板上，增大立杆的受力面积，增强架设的稳定性。 Before erection, put the jack base under the rickers to increase the force area of rickers and strengthen the erection stability. 架设用材料选用须符合下列要求： The scaffolding materials should comply with the following requirements: 架杆选用φ48mm，壁厚3.5mm的钢制管道，材质符合GB7008-79对Q-235A钢的要求。 Use the steel tubes φ48mm with 3.5mm thick wall as the scaffold poles. The materials should be in accordance with the requirements to steel Q-235A by GB7008-79. 扣件选用型号为KT-33-8的可锻铸铁，扣件紧固用螺栓选用材质为Q-235A钢制作。 Use the mollealle iron KT-33-8 to be the fasteners. Bolts to fix fasteners should be fabricated by steel Q-235A. 跳板选用材质为Q-235A钢制作，厚度不低于2mm。 Use steel Q-235A to fabricate the planks, with thickness 2mm or more. 脚手架搭设型式及设备平台安装顺序 Scaffolding Erection Type and Installation Sequence of Platform of Equipments 采用双排扣件式井字脚手架。 The scaffolding shall be double-row “#”-shape scaffolding with fasteners.