风道模流分析报告演示课件.pptVIP

* 原始的产品尺寸及特征(Part dimension wall thickness) 产品主体壁厚2.3mm The thickness is uniform on the main part surface: 2.3mm. * 网格统计 Mesh statistics 产品1出1 One mold with one cavity. 产品网格为双层面网格 Preprocess and mesh statistics * Material Data General: Recommended Processing: Rheology: 下图为PP GF20-05 材料的属性。 PVT properties: 产品材料信息 * Runner system layout Hot runner system layout One mold with one cavity. 热流道系统进胶示意 A B C D ?16 ?16 Outer:?16 Inner:?8 ?5 A C B D * Circuit Layout Circuit Layout 水路 示意 定模冷却水?19mm，共5路 定模水井?30mm * Circuit Layout Circuit Layout 水路 示意 动模冷却水?19mm，共5路 动模水井?30mm 滑块冷却水?12mm，共3路 滑块水井?19mm * Fill time Fill time 按住shift+F5播放动画 产品填充时间为3.528s,填充平衡。 * Fill time Fill time(contour) 产品填充时间为3.528s * Weld Lines Weld Lines Location 熔接线如红圈所示 * Air Traps Air Traps Location front reverse * Pressure at V/P switchover The V/P switchover time is at 3.48s, when the part volume is filled at 99% The V/P pressure is 40.58MPa. It is suitable for molding. Pressure distribution * Pressure at the end of fill Pressure at the end of fill COMMENT: The difference between max. and min. value in the press distribution on the part is about 32.46Mpa. * Flow Front Temp Flow Front Temp picture 表面流动前沿温度相差在16℃内,产品质量较好 * Shear Rate Shear Rate COMMENT: The shear rate is uniform on the part, It doesn’t exceed max value on the gate location. the limit value is 100000 1/s. 剪切速率在材料允许范围内。 按Shift+F5可播放动画 * System Pressure System Injection Pressure XY Plot (Taken at machine Nozzle) 最大注射压力：48.02MPa Max. injection pressure: 48.02MPa * Clamp Force Clamp Force XY Plot 最大锁模力：1075Ton Max. Clamp force: 1075Ton * Volumetric shrinkage at ejection Volumetric shrinkage at ejection 由图可知，产品表面的体积收缩率。 * Temperature part Temperature part picture Cavity Core * *