PB7200呼吸器Service Manual Ch11-12.pdf

SECTION SECTION Repair: Power Supply Assembly 11 11 The power supply assembly is a modular unit that supplies various voltages to the ventilator electronic system. The power supply assembly consists of a +5 V module, a +12 V module, a ±15 V module, and a power fail module. These modules are individually replaceable. In addition, depending on ventilator model, the power supply is augmented by a surge suppressor mounted above the power supply, and/or by a power line filter mounted in the utility panel. An isolation transformer is installed in later ventilator versions to step the voltage to the power fail module. This section describes removal, installation, testing, and adjustment of the power supply assembly and its components. Before repairing the power supply assembly, familiarize yourself with the warnings, cautions, and general repair instructions in Section 8. Warning • To prevent personal injury and equipment or property damage, ensure that electrical power sources and pneumatic sources are disconnected from the ventilator before servicing. • If ventilator must be serviced with the power on, be careful to avoid electrical shock. Avoid reaching into the ventilator. Follow accepted safety procedures for electrical equipment when testing, making connections, adjustments, or repairs. 11.1 Testing Output Voltages