毕业设计（论文）-自动变速箱液压系统的设计.docVIP

摘 要 （AT）国内自动变速器进口为主，国内的自动变速器技术，尤其是自动变速器液压系统的开发设计能力国外相比AMESim环境下建立了液压系统中部分阀的仿真模型并进行仿真分析，验证了计算的正确性。 关键词：；； Abstract Automatic transmission (AT) is an important part of modern vehicle transmission system. Automatic transmission technology has been in the mature stage of development in foreign countries, and Chinese technical level is relatively backward. Domestic automatic transmission mainly to import the main domestic automatic transmission technology, especially automatic transmission hydraulic system development and design capabilities compared with foreign technology has a certain gap, the lack of automatic transmission in the hydraulic system on a certain design and research and development capabilities. Based on the working principle of the automatic transmission hydraulic system, the design of the hydraulic system of the AT gearbox is carried out. Based on the hydraulic system functional requirements, the parameters of the actuator clutch are calculated and the parameters of the hydraulic system are determined. Part of the hydraulic system to draw a schematic diagram. And then calculate the hydraulic pump, accumulator and other hydraulic components of the parameters were selected, the shift valve was designed and calculated. According to the schematic diagram of the hydraulic system design scheme, the simulation model of the partial valve in the hydraulic system is established under the simulation software AMESim and the simulation analysis is carried out to verify the correctness of the calculation. Keywords: Automatic transmission；Hydraulic system；Shift slide valve；Simulation analysis 目录 摘 要 I Abstract II 1 绪 论 1 1.1 研究背景及意义 2 1.2 自动变速器的液压系统研究现状 3 1.3 本文研究的主要内容 6 2 AT变速器液压系统的方案设计 8 2.1 AT液压系统设计要求 8 2.2 供油调压和流量控制系统 10 2.3 换挡操纵液压系统 11 2.4 换挡品质控制系统 12 2.5 冷却和润滑系统 14 2.6 液压系统原理图 14 2.7 本章小结 15 3 液压系统元部件的参数计算和选型 16 3.1 换挡执行元件湿式离合器 16 3.1.1 湿式换挡离合器各挡位压紧力计算 16 3.1.2 湿式换挡离合器中流量的计算 18 3.1.3 执行元件湿式离合器工况图 18 3.2 换挡执行元件制动器参数计算 19 3.3 液压泵的计算选型 21 3.4 蓄能器的计算选型 22 3.5 换挡滑