思科第二学期期末试题及答案1.doc

 Close Window  Assessment System ? 1. Assessment Selection ? ? 2. Assessment Settings ? ? 3. Take Assessment ?  Take Assessment - ERouting Final Exam - CCNA Exploration: Routing Protocols and Concepts (Version 4.0) 窗体顶端 Time Remaining: 窗体底端 11 窗体顶端 Two routers need to be configured within a single OSPF area. Which two components need to be configured on both routers to achieve this? (Choose two.) the same process ID the same area ID network addresses and wildcard masks the same router ID the same loop back address 窗体底端 12 窗体顶端 Refer to the exhibit. R1 is configured properly for a single area OSPF, and R2 has been recently installed in the network. Which set of commands is required to configure a single area OSPF for the networks that are connected to R2? R2(config)# router ospf 1R2(config-router)# network 192.168.2.0 0.0.0.255 area 0R2(config-router)# network 10.1.1.0 0.0.0.3 area 0 R2(config)# router ospf 1R2(config-router)# network 192.168.2.0 0.0.0.255 area 0R2(config)# router ospf 2R2(config-router)# network 10.1.1.0 0.0.0.3 area 0 R2(config)# router ospf 1R2(config-router)# network 192.168.2.0 0.0.0.255 area 0R2(config-router)# network 10.1.1.0 0.0.0.3 area 1 R2(config)# router ospf 1R2(config-router)# network 192.168.2.0 0.0.0.255 area 0R2(config-router)# network 10.0.0.0 0.0.0.3 area 1 窗体底端 13 窗体顶端 Which two statements are true about the EIGRP successor route? (Choose two.) It is saved in the topology table for use if the primary route fails. It may be backed up by a feasible successor route. It is used by EIGRP to forward traffic to the destination. It is flagged as active in the routing table. After the discovery process has occurred, the successor route is stored in the neighbor table. 窗体底端 14 窗体顶端 Refer to the exhibit. Which path will traffic from the 172.16.1.0/24 network take to get to the 10.0.0.0/24 network? ADC ABC It will load balance the traffic between ADC and ABC It