[工学]机械工程英语_第二部分翻译.doc

Unit 3数控编程 Unit 3 Programming for Numerical Control A program for numerical control consists of a sequence of directions that causes an NC machine to carry out a certain operation, machining being the most commonly used process. Programming for NC may be done by an internal programming department, on the shop floor, or purchased from an outside source. Also, programming may be done manually or with computer assistance.数控编程由一系列方向构成，这些方向导致数控车床执行某种操作，加工是最常用的进程。数控车床编程由内部编程部门来完成，在车间里，或者从外部源购买。编程还可以手动或者在计算机辅助下来完成。 The program contains instructions and commands. Geometric instructions pertain to relative movements between the tool and the workpiece. Processing instructions pertain to spindle speeds, feeds, tools, and so on. Travel instructions pertain to the type of interpolation and slow or rapid movements of the tool or worktable. Switching commands pertain to on/off position for coolant supplies, spindle rotation, direction of spindle rotation, tool changes, workpiece feeding, clamping, and so on. 程序包括指令和命令。几何指令涉及刀具和工件间的相对移动。进程指令涉及主轴速度，进给以及道具等。行动指令涉及插值的类型以及刀具或者工作台的缓慢和快速移动。切换命令涉及到开/关冷却液供给状况，主轴旋转，主轴方向，换刀，工件进给，夹具固定等等。 (1) Manual programming. Manual part programming consists first of calculating the dimensional relationships of the tool, workpiece, and worktable, based on the engineering drawings of the part, and manufacturing operations to be performed and their sequence. A program sheet is then prepared, which consists of the necessary information to carry out the particular operation, such as cutting tools, spindle speeds, feeds, depth of cut, cutting fluids, power, and tool or workpiece relative positions and movements. Based on this information, the part program is prepared. Usually a paper tape is first prepared for trying out and debugging the program. Depending on how often it is to be used, the tape may be made of more durable mylar. （1）手工编程。手工编程包括根据部分工程图纸首先算出刀具，工件以及工作台的尺寸关系，继而决定执行的操作和工序。那么一个包括执行特定操作所需必要信息的程序表就准备好了，例如刀具切削，主轴转速，进给，切削深度，切削液，以及刀具或者工件间的相对位置或者移动。根据这