YOKOGAWA培训手册87.pdfVIP

7. Daily Maintenance And Questions Chapter7 Daily Maintenance and Questions In this chapter, we will introduce the daily maintenance of CENTUM CS3000 ，in order to make sure the system run reliably, stably and efficiently. Besides, we will answer some the frequently asked questions. - 0 - 7. Daily Maintenance And Questions 7.1 Hardware maintenance 1. Check the indicator of the hardware regularly, to see if there is any abnormal situation. 2. Replace the bad cards. 3. If there is no suitable alternative cards, you can change the channels Note: when you are replacing the cards, pay attention to the following questions: ◆ If there is dust or dirt around the device, clean it up with a vacuum cleaner or a soft cloth. ◆ Don’t install or remove the cards or cables, when the power is on. ◆ In the course of maintenance, it is necessary to wear the anti-static wrist to prevent damage cards due to static. 7.2 FCS prevention procedures Measures to prevent static: （1） When transporting or carrying maintenance parts, put them into a anti-static bag first of all. （2 ） In the course of maintenance ，connect the anti-static wrist with a wire which is connected to the ground through a 1-ohm resistance. （3 ） When checking the card that contains a battery, set the battery switch to OFF position or remove the battery. （4 ） When doing the maintenance on a table, the table must be covered with anti-static mat, which is connected to the ground through a 1-ohm resistance. 7.3 Daily maintenance Human interface station （HIS ）always check the status of each FCS from time to time ，when there is something wrong with the FCS, it will inform the operator