松下程控交换机ncp[精品].pptVIP

As I already explain, Conference group call feature is enhanced for paging to 2.4G Wireless. All paged members can listen to both announcement and reply from some user. LCO : loop start GCO : Grand start * End explain about NCP/TDE Version4. Contents are following. At first points to sell These 5 items are main enhanced features. From Ver4 VoIP capacity is expanded, so it is possible to correspond to the demand of big capacity. Though IP-TSW speech path is expanded up to 113ch, but it is necessary to use improved MPR card. I will explain the detail later. IP-PT : NCP500 : 40 - 128 NCP1000 : 64 - 128 SIP Phone : NCP500 : 32 - 128 NCP1000 : 64 - 128 IP-TSW Speech Path : - 113ch SIP Trunk : 32ch - 64ch This page is shown about IP-PT capacity. Only you prepare IP-PT and Activation Key, you can use up to 128 IP-PTs or SIP phones without PBX replacement, PSU replacement and IP-extension card. This page is shown about SIP account contract. Previously if you want to operate 32ch, it is necessary to contract two accounts. But from Ver4, only you prepare Activation Key, it is possible to operate up to 64ch by one SIP account contract. 参考 ITSP that can be used are following, ITSP Name: / isphone / Symbio Networks / Vonic / ECN From ver4, network features are enhanced. Basically major call features within single PBX will be supported for the calls over the network. The enhancement of feature transparency are provided to user within a network environment across 100 sites. But CA application and NDSS key operation is limited within 8 PBXs networking. Up to now, only the terminal under the PBX was able to be controlled. Ver4 provides enhancement of feature transparency to users within a network environment. So it is the same as the operation of one PBX. AKY for Software Upgrade to Enhanced Version is required to use this feature Up to now, All ring were available for network. In addition, UCD and priority hunting are also available from Ver4. Automati