官方说明书Honewell R7184A,B,G,P,U Electronic Oil Primary, EnviraCOM Enabled 数据手册.pdfVIP

R7184A,B,G,P,U Electronic Oil Primary, EnviraCOM™ Enabled INSTALLATION INSTRUCTIONS APPLICATION Limited Recycle This feature limits the number of recycle trials (for each The R7184A,B,G,P,U Electronic Oil Primary is a line call for heat) to a maximum of three trials. If the flame is voltage, safety rated, oil primary control for residential oil lost three times and does not successfully satisfy a call fired burners used in boilers, forced air furnaces and for heat, the R7184 locks out. water heaters. The R7184A,B,G,P,U used with a cad cell flame sensor, operates an oil burner and optional oil Pump Priming Cycle valve. The primary controls fuel oil, senses flame, controls ignition spark (either interrupted or intermittent) To facilitate purging air from the oil lines and filters, the and notifies a remote alarm circuit when in lockout. R7184 can be placed in a purge routine by pressing and releasing the reset button during the safety check, The R7184 can be used with both hydronic and forced air delayed valve-on, ignition or carry-over periods. The systems. When used with hydronic systems, line voltage lockout timing will be extended to four minutes and the switching Aquastat® Controllers normally provide for the ignition set in the intermittent mode for this cycle only. starting and stopping of the combustion sequences. With The R7184 automatically reverts to its labeled interrupted forced air systems, both mechanical and electronic low and safety switch timing states (as applicable). The pump voltage thermostats control the starting and stopp