毕业设计（论文）-2m铣刨机行走系统设计汇.docx

二 ○ 一 一 届 毕 业 设 计2m铣刨机行走系统设计学 院： 工程机械学院 专 业：机械设计制造及其自动化姓 名： 学 号： 指导教师： 完成时间： 2011年6月16号 摘要随着公路交通事业的发展，以大型铣刨机为主要设备的机械化养护作业方式已经在我国广泛采用。大型铣刨机行走系统一般都采用四轮独立液压驱动，而路面的损坏程度、路面材料的硬度、铣削层的深度以及刀具的情况等都会对行走液压驱动系统产生影响。为了提高铣刨机的使用性能和工作可靠性，保证铣刨机具有较高的生产率和作业质量。本文对2米铣刨机的行走液压系统进行了研究。在对2米铣刨机国内外技术现状调研的基础上，确定了2米铣刨机行走系统的参数；分析了履带式铣刨机的运动学和动力学特性；设计了路面铣刨机行走液压系统,完成了行走液压系统主要参数的设计计算、元件选型和校核。探讨了了液压系统的控制方式。关键词:履带式铣刨机，行走系统，液压系统，设计AbstractWith the development of road transport, the mechanical maintenance operations, using large milling machine as the main equipment, have been widely used on the highway. The moving system of milling machine is generally four-wheel independent hydraulic driving. The damage extent of the roads, the hardness of the road, the depth of the milling and the condition of the tools will have an impact on the moving hydraulic driving system.In order to increase the operation performance and reliability of milling machine, ensure the milling machine with higher productivity, operation quality and economic benefit, increase the performance of milling machine, the moving system of 2-meter milling machine have been discussed and designed in this paper.On the basis of analyzing the performance requirements of the 2-meter milling machine and moving system conditions, the overall parameters of the 2-meter milling machine have been determined; kinematics and dynamics analysis of the track milling machine have been done; power analysis of the moving system and milling rotor system have been done. According to the rules of kinematics, dynamics of 2-meter tracked milling machine and the requirements of milling machine moving system, the hydraulic moving system and automatic power distribution control programme which meet the operating characteristics of the milling machine have been designed; the main control programme of hydraulic system and the match parameters between hydraulic moving system and engine have been determined.Keywords：track milling machine，moving system，hydraulic system，de