TDSCDMA_RRC_测量控制及测量报告.docVIP

8.4 Measurement procedures 8.4.0 Measurement related definitions UTRAN may control a measurement in the UE either by broadcast of SYSTEM INFORMATION and/or by transmitting a MEASUREMENT CONTROL message. The following information is used to control the UE measurements and the measurement results reporting: 1. Measurement identity: A reference number that should be used by the UTRAN when setting up, modifying or releasing the measurement and by the UE in the measurement report. 2. Measurement command: One out of three different measurement commands. - Setup: Setup a new measurement. - Modify: Modify a previously defined measurement, e.g. to change the reporting criteria. - Release: Stop a measurement and clear all information in the UE that are related to that measurement. 3. Measurement type: One of the types listed below describing what the UE shall measure. Presence or absence of the following control information depends on the measurement type 4. Measurement objects: The objects on which the UE shall measure measurement quantities, and corresponding object information. 5. Measurement quantity: The quantity the UE shall measure on the measurement object. This also includes the filtering of the measurements. 6. Reporting quantities: The quantities the UE shall include in the report in addition to the quantities that are mandatory to report for the specific event. 7. Measurement reporting criteria: The triggering of the measurement report, e.g. periodical or event-triggered reporting. 8. Measurement Validity: Defines in which UE states the measurement is valid. 9. Measurement reporting mode: This specifies whether the UE shall transmit the measurement report using AM or UM RLC. 10. Additional measurement identities: A list of references to other measurements. When this measurement triggers a measurement report, the UE shall also include the reporting quantities for the measurements referenced by the additional measurement identities. All these measurement parameters