ULTRASITE 7601,7604处理.doc

7601、7604告警处理 一、告警名称：7601，7604 附加信息：Rx levels differ too much between main and diversity antennas 二、告警分析： 经过对现网中7601、7604告警的过滤，发现大部分的告警信息显示为Rx levels differ too much between main and diversity antennas，主要是出现在EDGE的bts。 含义为：主分集接收信号差异过大 告警触发方式： BTS对每个载频的主分集接收信号强度进行评估，通过计算得到每个载频的主分集接收信号的RSSI值，并对RSSI值之间的差异进行评估，如果单载频的主分集或载频之间的RSSI值相差10以上，就会触发基站产生7601、7604告警。 告警产生的原因： 载频主分集接收信号差异过大产生的7601、7604可能是由于载频故障、连线损坏、分路器和合路器故障、馈线问题、天线问题造成。现网少量的7601、7604属于这种情况，一般出现在非EDGE的bts。 载频间接收信号差异过大产生的7601、7604可能是由于载频质量的差异产生。现网大部分的7601、7604属于这种情况，一般出现在EDGE的bts。 三、告警处理 NOKIA NED中对告警7601、7604 Rx levels differ too much between main and diversity antennas的处理建议 1. Check the RSSI measurements by BTS Manager. Note: From BTS Manager, open the RSSI Comparison Values dialog box or Site Information dialog box to pinpoint the alarming RSSI value and antenna. From CX5 CD1.0 onwards the history of last active RSSI alarms will provide the information of which antenna line was detected faulty. Note: There is a hysteresis of 2 dB in the cancellation of the alarm. The alarm is cancelled when the RSSI measurement result is less than RXDL -2 dB. 2. Check and measure the antenna lines. 3. Check the BTS RF cables and connections. 4. Replace the combiner unit. Check that the RXDL parameter at the BSC is set to a reasonable value, taking into account the siteconditions in order to prevent unnecessary alarms. 5. Replace the TSxx unit. Note: With BTS SW CX4.1 to CX4.1 CD2.0, the alarm may be generated unnecessarily when the Relative Difference is less than the set difference from the BSC. Check the alarm reason from the RSSI measurements by BTS Manager. If the reason is Relative Difference, increase the RSSI alarm threshold value at the BSC. NOKIA的告警处理建议说明在目前BTS的软件版本CX4.1 to CX4.1 CD2.0中部分由于Rel.diff值过大产生7601、7604是BUG问题 告警处理建议： 1、在基站端看到有7601、7604告警时，检查基站的RSSI Value或者取基站的siteinformation.看该告警是有哪个参数引起的（Avg.difference, difference, Rel.difference) 2、对7604的具体处理方法可以如下进行： A，通过BTS manager查看7604的信息，通过对基站RSSI值惊醒检查判断故障点。如果是由于主分集接