MSCXFlow2011实例.pptVIP

XFlow™ Training Workshop 03 Ball Check Valve Overview Manufacturing Single phase Internal aerodynamics Constrained geometry Spring force with damping Post-processing Stream lines WS03 – Ball Check Valve Engine: Dimension: 3D Single phase internal Thermal model : isothermal Acoustic analysis: off Global attributes: Automatic turbulence model No gravity laws Initial velocity field: 0 m/s Initial gauge pressure field: 0 Pa 1. Environment: Single phase internal WS03 – Ball Check Valve Fluid: Water Thermodynamic properties Viscosity model: Newtonian 2. Materials: Water WS03 – Ball Check Valve 3. Geometry: Import the valve and sphere Import geometry: Hit the button Browse the files WS03 – Ball Check Valve 3. Geometry: Check normals orientation Select Geometry + Right-click GOOD BAD WS03 – Ball Check Valve 3. Geometry: Adjust location/orientation Valve: Position (0,0,0) Orientation (0,180,0) Sphere: Position (-0.014,0,0) Orientation (0,0,0) WS03 – Ball Check Valve 3. Geometry: Create inlet/outlet Inlet: Use the edge mode selection Select edges of the surface WS03 – Ball Check Valve 3. Geometry: Create inlet/outlet Inlet: Hit the button “Create Surface” A new “Shape” item is added in the tree Outlet: Same operation WS03 – Ball Check Valve 3. Geometry: Apply boundary conditions Valve: Behavior: Fixed Boundary Condition: Wall Sphere: Behavior: Constrained Mass: 1 kg Restitution coefficient: 0.5 Static friction coefficient: 0.5 Dynamic friction coefficient: 0.5 Degrees of Freedom: X Translation Spring force in X: -250*(px-(-0.014)) Boundary Condition: Wall WS03 – Ball Check Valve 3. Geometry: Apply boundary conditions Inlet: Behavior: Fixed Boundary Condition: Mass Flow Mass flow law: if(t1.5,0.2,0) Outlet: Behavior: Fixed Boundary Condition: Gauge pressure outlet Gauge pressure law: 0 Pa WS03 – Ball Check Valve Time discretization: Simulation time: 2s Automatic time step calculation Courant number: 1 4. Simulation: Set the nume